Daily Blender Tip – 3 ways to straighten Edge Loops
Jan van den Hemel writes:
Straightening Edge Loops is a fundamental modeling skill that you should know at least one way to achieve. So here’s three! Check out this short video to learn them all.
Grög the Adventurer
Nice! But the instructions were too fast in my opinion…
Thanks Francisco, I’ll try to slow it down in the future ;-)
Please don’t slow anything down! It’s great the way it is! I can understand you loud and clear and I believe most of us can. For those that cannot, there are always “space”, “,”, “.” and cursor buttons to navigate… and not to mention they can easily replay this one little minute as many times as needed.
One cannot please everyone so why bother with the minority?
Keep up the good work – one of the best channels out there.
SICKBOY ………. I take it by your comment YOUR THE MAJORITY ???
Keep calm and replay the video if it’s too fast for you, or play it at half the speed. It’s really an easy task.
THAT’S the point and not which side I belong to.
Just to not get off on the wrong foot here – I replay the videos myself all the time, even the slow ones if I need to, because sometimes it’s hard to keep concentration and pick up everything at once.
The authors are busy enough putting up those videos at regular basis, I don’t think there’s the need to burden them with things we can easily compensate for from our end.
Ditto on the speed (slower). You are very talented, but newbies are a little slower on the up take of instruction.
Thanks for your generous offerings here.
Cheers
MR HOLLYWOOD
Thanks for letting me know! I’m sticking to the 1-minute (maximum) length, so sometimes I have no choice but to be in a hurry. However, I’ll try to keep it at a reasonable pace. And hey… you can always read the e-book at your own pace ;-) –> http://www.blendersecrets.org/book